+- How2pass.com Forums (https://www.how2pass.com/forum)
+-- Forum: CCNP (https://www.how2pass.com/forum/forum-6.html)
+--- Forum: CCNP ENARSI 300-410 Forum (https://www.how2pass.com/forum/forum-15.html)
+--- Thread: QID: RTE140 (/thread-530.html)
QID: RTE140 - marca1976 - 01-25-2011
I hope I am not violating the posting rules by re-posting the question in the forum...
I'm not certain on the answer for this question. The correct answer shows that the router will prefer the next hop of
172.26.1.1 for packets destined to 192.168.1.0 network. Is this simply because of the lower router-id for the eBGP peers?
Or is there some sort of typo here where acl 65 should really be acl 20...? ? ? I am assuming a default local-pref of 100 for
each peer..
router bgp 65001
neighbor 172.16.1.1 remote-as 65001
neighbor 172.26.1.1 remote-as 65555
neighbor 172.26.1.1 route-map local_pref in
neighbor 172.30.1.1 remote-as 65510
!
route-map local-pref permit 10
match ip address 20
set local-preference 200
!
access-list 65 permit 192.168.1.0 0.0.0.255
!
Re: QID: RTE140 - bryanrobh - 01-25-2011
I remember this question. I think they messed up on the ACL number and your right it should be 20 instead of 65. Thats the only way it makes any sense.
Re: QID: RTE140 - sdunn96 - 03-17-2011
Just saw this post
I posted the same thing, so I am glad I am not the only one confused.....
But technically speaking, the answer for the question is wrong, if the configuration is accurate as it is written.
I think they messed up on the ACL
It should be 20, and not 65