03-17-2011, 05:11 PM
QID:RTE140, For BGP, regarding the Exhibit,
I think the ACL that is referenced is incorrect.....
"match ip address 20"
And the ACL is "access-list 65 permit...."
And also::
Hands On Lab #4, OSPF Virtual Link
This has the IPv6 addresses.
I am confused by the Running Config between R2 and R3
They are configured w/ IPv4 Addresses, but yet show ospf for IPv6 enabled on the interfaces.
I don't think it will work that way.
Can anyone smarter than I, shed some light on those two problems??
I think the ACL that is referenced is incorrect.....
"match ip address 20"
And the ACL is "access-list 65 permit...."
And also::
Hands On Lab #4, OSPF Virtual Link
This has the IPv6 addresses.
I am confused by the Running Config between R2 and R3
They are configured w/ IPv4 Addresses, but yet show ospf for IPv6 enabled on the interfaces.
I don't think it will work that way.
Can anyone smarter than I, shed some light on those two problems??