08-14-2012, 06:29 PM
Hi Everyone,
I'm following the written answer exactly as it is shown and when I click "Done" and "End Test" it shows that I fail the simulation. Should I be doing something else in order to have the simulation properly identify my entries?
I can ping the other routers successfully, and I do a "copy run start" at the end also.
Could it be my version of java? Browser version?
A couple general questions for you as well:
Do these simulations require the commands to check the configuration (show ip route, show ip ospf, etc) in order to mark them complete?
Is there a particular order that the commands must be entered in so that the sim marks it as successful?
How about on the actual exam?
I'm following the written answer exactly as it is shown and when I click "Done" and "End Test" it shows that I fail the simulation. Should I be doing something else in order to have the simulation properly identify my entries?
I can ping the other routers successfully, and I do a "copy run start" at the end also.
Could it be my version of java? Browser version?
A couple general questions for you as well:
Do these simulations require the commands to check the configuration (show ip route, show ip ospf, etc) in order to mark them complete?
Is there a particular order that the commands must be entered in so that the sim marks it as successful?
How about on the actual exam?