04-13-2009, 06:58 PM
I don't know actually I was somewhat confused last evening and did not realize that you needed to selected each lab individually (new to this whole Cisco game)... been a Bay/Nortel engineer for years however,
I tried this question several times and at first I fell for the deny tcp any any gig myself and then read the question carefully
Then I used access-list 101 deny tcp any host 192.168.33.2 eq 23 .. and followed through for the next network and then the access-list permit ip any any
then, applied 101 in to both e0 and s0 and it failed me...
So, I tried it again this time printing out the answer.... it failed me
I tried again this time however, I typed in using no abbreviations: enable, configure terminal, copy running-config startup-config instead of the en, conf t, copy run start (which all worked by the way and it passed me) but only when I used access-list 100
Maybe I am just to old and set in my ways to follow along with all of this...
I tried this question several times and at first I fell for the deny tcp any any gig myself and then read the question carefully
Then I used access-list 101 deny tcp any host 192.168.33.2 eq 23 .. and followed through for the next network and then the access-list permit ip any any
then, applied 101 in to both e0 and s0 and it failed me...
So, I tried it again this time printing out the answer.... it failed me
I tried again this time however, I typed in using no abbreviations: enable, configure terminal, copy running-config startup-config instead of the en, conf t, copy run start (which all worked by the way and it passed me) but only when I used access-list 100
Maybe I am just to old and set in my ways to follow along with all of this...