12-31-2009, 02:33 AM
Ok so I how2pass was very helpfull and I thought I passed before getting my 720 :-\.
The NAT question came up and I responded word for word but I don't think it was good enough. They gave me the same question but the ip addresses were different, I read the rules and didn't see that posting the addresses cant be posted but if Im wrong please feel free to edit or delete my post. I am mod on another forum and understand.
So the Private were 192.168.123.65-194
The Public was 198.18.47.161-166
I wasn't given anything but the name of the router which was Munford.
So...
access list 2 permit 192.168.123.64 0.0.0.30
ip nat pool list 2 198.18.47.161 198.18.123.166 netmask 255.255.255.248
ip nat inside source list 2 pool munford overload
the inside and outside interfaces were done already so I just saved my info with the copy run start.
Now my question is do I use munford? should I have used "cisco"? The other NAT deals Ive seen had the inside pool as the public addresses and the outside as the 192....
The reason I asked was the message of: Implement, verify and troubleshoot NAT and ACL in a medium sized Enterprise branch office, which I would think was the NAT sim.
Im sure I turned and the interfaces and saved my config if asked.
The only question I did not know (in my mind) was a question about Rapid PVST, Im not even sure I have heard of that one but I think I can find it using a search engine.
Thanks in advance.
The NAT question came up and I responded word for word but I don't think it was good enough. They gave me the same question but the ip addresses were different, I read the rules and didn't see that posting the addresses cant be posted but if Im wrong please feel free to edit or delete my post. I am mod on another forum and understand.
So the Private were 192.168.123.65-194
The Public was 198.18.47.161-166
I wasn't given anything but the name of the router which was Munford.
So...
access list 2 permit 192.168.123.64 0.0.0.30
ip nat pool list 2 198.18.47.161 198.18.123.166 netmask 255.255.255.248
ip nat inside source list 2 pool munford overload
the inside and outside interfaces were done already so I just saved my info with the copy run start.
Now my question is do I use munford? should I have used "cisco"? The other NAT deals Ive seen had the inside pool as the public addresses and the outside as the 192....
The reason I asked was the message of: Implement, verify and troubleshoot NAT and ACL in a medium sized Enterprise branch office, which I would think was the NAT sim.
Im sure I turned and the interfaces and saved my config if asked.
The only question I did not know (in my mind) was a question about Rapid PVST, Im not even sure I have heard of that one but I think I can find it using a search engine.
Thanks in advance.