ENARSI 300-410 VRF Lab

[jupertino]

Yeah, I noticed that too. That's an issue as well as the sub interfaces. They should be /30's but in the solution, they're written as /24's.

The interfaces you mentioned should indeed be e0/1 for cu-green on both R1 and R2.

The proper solution is below.

VRFs



--R1--
conf t
interface e0/0
ip vrf forwarding cu-red
ip appdress 192.168.1.254 255.255.255.0
interface e0/1
ip vrf fowarding cu-green
ip address 192.168.20.254 255.255.255.0

interface e0/2.100
ip vrf forwarding cu-red
ip address 10.10.10.1 255.255.255.252
interface e0/2.200
ip vrf forwarding cu-green
ip address 10.10.20.1 255.255.255.252

router bgp 65000
address-family ipv4 vrf cu-red
redistribute connected
neighbor 10.10.10.2 remote-as 65000
neighbor 10.10.10.2 activate
exit-address-family
address-family ipv4 vrf cu-green
redistribute connected
neighbor 10.10.20.2 remote-as 65000
neighbor 10.10.20.2 activate

wr


--R2--
conf t
interface e0/0
ip vrf forwarding cu-red
ip address 192.168.2.254 255.255.255.0
int e0/1
ip vrf forwarding cu-green
ip address 192.168.22.254 255.255.255.0

interface e0/2.100
ip vrf forwarding cu-red
ip address 10.10.10.2 255.255.255.252
interface e/2.200
ip vrf forwarding cu-green
ip address 10.10.20.2 255.255.255.252

router bgp 65000
address-family ipv4 vrf cu-red
redistribute conneced
neighbor 10.10.10.1 remote-as 65000
neighbor 10.10.10.1 activate
exit-address-family
address-family ipv4 vrf cu-green
redistribute connected
neighbor 10.10.20.1 remote-as 65000
neighbor 10.10.20.1 activate

wr