I am not able to disable the timer, dose anyone have an idea why?

Question is asking how many non-overlapping 5GHz channels there are if UNII-2c isn't available. Correct answer should be six non-overlapping channels, not four. Refer to the following chart: https://www.mbreviews.com/wp-content/upl...scaled.jpg

For 40MHz channels, there are two in UNII-1, a further two in UNII-2a and another two in UNII-3.

Answer should be adding a sequence of 5 to the access list to log the specified network traffic.

The currently designated correct answer doesn't seem to account for the fact there is already an ACL entry for the 172.16.0.0 0.0.15.255, which means the 172.20.10.0 network would be matched against it.

The website shows there was no update to ENCOR questions since October 4, 2022:

https://www.how2pass.com/encor-350-401-p...stions.php

Can you please check and let us know? Are the questions are still up to date with the current exam?

Thank you so much!

Hello,
I guess the answer here is incorrect.

I tested it in GNS3 and it should be "Include a valid source interface keyword".

Regarding to the linked Cisco document:

https://www.cisco.com/c/en/us/support/do...ing-I.html

It also shows to use a source IP.

Is the diagram for AR291 missing?
Without a diagram, how do we know the loopback IP addresses for source and destination to decide the right answer?

Can someone help me with the answer for AR208?

I do not understand it. Maybe there is a network diagram missing?

When I configure a similar setup in GNS3, I get the network advertised. I do not need the "ip ospf network point-to-point" command to have the loopback route advertised in OSPF.

The answer is incorrect and the explanation is aligned to a different question.

Should the standard ACL not be placed outboung on the SW1 G1/10 if, as that is closest to the destination?

The only logical answer is to configure AS_PATH prepend for the current best path.
Higher local pref is preferred so the current answer seems incorrect?