Hello
I need to get the CCNA Security cert also as it is a DoD IAT Level Certification required for most DoD jobs. Where can I get those practice questions and answers?
Matt

Just when I think I am almost ready to sit for the exam new questions are added (again).  I noticed 14 new questions added to the practice exam.  Is there more to come?

QID:285 (dot symbol between ip address and mask)

3 of 4 answers have error in line 4th (IP ADDRESS and MASK are connected by ".") ===> 192.168.1.1.255.255.255.0

Hello,

In QID:AR231

IP address cannot use "," between octets ==see==> [172,16.1.1 and 10,1,1.0]

(...) The IPv4 portion of the address must contain three periods and four octets(...)

The radio selection button is "splitting" the multiple choice answers in half on QID: AR015.  This makes choosing the correct answer very confusing because half of the correct config statement sits above the selection radio button.  The other half of the config is at the radio button, but then runs into the beginning of the next multiple choice option, as if it is a part of the next choice.  Please re-format this QID to eliminate all of the confusion.

Greetings H2P,
On QID's: AR468 and AR138  - All routers in each exhibit are labeled R1.  Please fix for accuracy.

Which IPsec transport mode encrypts the Ip header and the payload?

Uhm, tranport mode doesn't encrypt the IP Header only the payload. 
And why is the question asking Which transport mode, that doesnt make senes at all. Transport is an IPsec mode itself.

I think the question should state "Which IPsec mode encrypts the IP header and the payload?" Answer: Tunnel Mode

Which characteristic differentiates the concept of authentication from authorization and accounting? 
A. Identity verification (THIS IS AUTHENTICATION)
B. consumption-based billing 
C. service limitation (this is authorization)
D. user-activity logging (this is accounting)

Correct Answer: user activity logging

This is wrong, the correct answer should be identity verification 

The exhibit shows ip address 107.73.65.64 but the answer states 10.73.65.66

what is the benefit of a point to point leased line?
I think it is simplicity of configuration but it says full-mesh capability is th correct answer, after research i still believe i am right. Someone please correct me or back me up I need help.