I am currently subscribed to ENARSI with a max question pool of over 530, but if I may ask here, what is the maximum
pool of questions for the ENCOR? I may begin here, thanks.

Hello,

I have a question to CCNA Test #08 Recently added/modified questions.

Modified means Cisco has changed a little thing in question or answers? e.g. other IP addresses?
Are these kind of questions moved from the "topic" area to Test #08 or they remain where they are and exist twice?

With third and second last update the number of over all questions remained the same (I think it were 869 questions). Only with the last update the total number of questions has increased to 926.

An explanation would be nice.

Best regards!

Hi, I have paid for the CCNP 350-401 but i cant find link to tests and other resources included in the package

I am not able to disable the timer, dose anyone have an idea why?

Question is asking how many non-overlapping 5GHz channels there are if UNII-2c isn't available. Correct answer should be six non-overlapping channels, not four. Refer to the following chart: https://www.mbreviews.com/wp-content/upl...scaled.jpg

For 40MHz channels, there are two in UNII-1, a further two in UNII-2a and another two in UNII-3.

Answer should be adding a sequence of 5 to the access list to log the specified network traffic.

The currently designated correct answer doesn't seem to account for the fact there is already an ACL entry for the 172.16.0.0 0.0.15.255, which means the 172.20.10.0 network would be matched against it.

The website shows there was no update to ENCOR questions since October 4, 2022:

https://www.how2pass.com/encor-350-401-p...stions.php

Can you please check and let us know? Are the questions are still up to date with the current exam?

Thank you so much!

Hello,
I guess the answer here is incorrect.

I tested it in GNS3 and it should be "Include a valid source interface keyword".

Regarding to the linked Cisco document:

https://www.cisco.com/c/en/us/support/do...ing-I.html

It also shows to use a source IP.

Is the diagram for AR291 missing?
Without a diagram, how do we know the loopback IP addresses for source and destination to decide the right answer?

Can someone help me with the answer for AR208?

I do not understand it. Maybe there is a network diagram missing?

When I configure a similar setup in GNS3, I get the network advertised. I do not need the "ip ospf network point-to-point" command to have the loopback route advertised in OSPF.